Wyko Remote Control Filmslide Projector
Projector
Wyko Remote Control Filmslide Projector
ca 1926
Metal, plastic, and glass
DescriptionBlack, vaulted, electric driven, 35mm film strip projector with 2 inch lens, 200 watt lamp in black plastic case.
Inscriptions Typed in black on instruction sheet: INSTRUCTIONS For Operating the Wyko Remote Control Filmslide Projector 1 Connect the plug to any light socket, connect both wires to projector. Stand as in Fig.1. 2 Remove the filmslide roll from the small can and hold it so that center of film pulls out in anti-clock wise direction- 3 Insert roll in container on top of projector, extended portion first; pull extended portion from center of roll and place over sprocket. 4 Swing the lens mount back into position and insert the loose end of the film inthe automatic take-up. 5 Turn on the light and focus y turning the lens until the picture is clear on the wall or screen. 6 Frame by pulling sprocket out and turning until the full picture is on the screen. Projector may be tilted by loosening knurled screw on lever near counterweight; tilt to proper angle and tighten screw- 7 Operate by merely pressing the hand lever or the switch for remote control. Do not hold switch down. 8 By pulling the film stripper (Fig. Viii), the filmslide is removed all ready to replace in container or to be used again. No rewinding by hand. 9 All projectors are set for use on A.C. current when shipped. If you use D.C. throw the switch back of the automatic take-up to the opposite position. WYKO PROJECTOR CORPORATION 130 W. 46th Street, New York, N.Y.
